Reverse Sear Tenderloin On The @pkgrills #pk360

View this post on Instagram

Reverse Sear Tenderloin On The @pkgrills #pk360. Lightly coat with Olive Oil. Thinly slice up garlic and insert tip of knife every three or four inches to slide garlic slivers in. Coarse salt, black pepper, gunpowder seasoning and Montreal Steak Seasoning. Set up PK 360 for offset smoking with a chimney and a half of unlit charcoal in the right side of the pit. Cherry wood for smoke. Place 10 briquettes in chimney and get them glowing red and dump on one corner of the unlit charcoal. Close lid and wait for temps to come up to 200 degrees. Once pit reaches 200 lay a sheet of foil or aluminum tray on charcoal grate underneath where the tenderloin will sit to catch drippings. Set cooking grate on, place tenderloin above the foil on opposite side from the coals. Place remote temperature probe in the thickest part of the tenderloin and close the lid. Close the bottom vent under the meat side and close the top vent over the coals. Close the top vent over the meat about half way or more to keep pit temps in the smoking range between 200-250. You may have to adjust the vents if you see the pit temps spike past 275. Really anything between 200-275 I wouldn't bother fussing with the vents. Once the remote digital thermometer reads 115 open the lid, knock the dust off the coals that are going and use your tongs to make sure you have an even later of good hit coals. Next, take the tenderloin from the offset side and place them over the coals to get a nice sear. Maybe 30 seconds, then roll it, 30 seconds then roll again, till all sides have the color you want. Next take it off, loosely wrap in foil making sure there's a little air gap to let out steam. Let sit up to a couple hours before slicing. Make sure to collect the juices in the bottom of the foil. That's liquid gold. Pour it over your sliced tenderloin. This method will produce edge to edge perfect rare tenderloin with an incredibly flavorful crust. We usually do rib roast the same exact way and it's fantastic. This is actually even better. #BBQ #bbqporn #foodie #foodporn #instafoodie #grilling #portablekitchen #GloucesterMA #northeastbbq #rublife #barbeque

A post shared by Joey C (@captjoe06) on

Reverse Sear Tenderloin On The @pkgrills #pk360. Lightly coat with Olive Oil. Thinly slice up garlic and insert tip of knife every three or four inches to slide garlic slivers in. Coarse salt, black pepper, gunpowder seasoning and Montreal Steak Seasoning. Set up PK 360 for offset smoking with a chimney and a half of unlit charcoal in the right side of the pit. Cherry wood for smoke. Place 10 briquettes in chimney and get them glowing red and dump on one corner of the unlit charcoal. Close lid and wait for temps to come up to 200 degrees. Once pit reaches 200 lay a sheet of foil or aluminum tray on charcoal grate underneath where the tenderloin will sit to catch drippings. Set cooking grate on, place tenderloin above the foil on opposite side from the coals. Place remote temperature probe in the thickest part of the tenderloin and close the lid. Close the bottom vent under the meat side and close the top vent over the coals. Close the top vent over the meat about half way or more to keep pit temps in the smoking range between 200-250. You may have to adjust the vents if you see the pit temps spike past 275. Really anything between 200-275 I wouldn’t bother fussing with the vents. Once the remote digital thermometer reads 115 open the lid, knock the dust off the coals that are going and use your tongs to make sure you have an even later of good hit coals. Next, take the tenderloin from the offset side and place them over the coals to get a nice sear. Maybe 30 seconds, then roll it, 30 seconds then roll again, till all sides have the color you want. Next take it off, loosely wrap in foil making sure there’s a little air gap to let out steam. Let sit up to a couple hours before slicing. Make sure to collect the juices in the bottom of the foil. That’s liquid gold. Pour it over your sliced tenderloin. This method will produce edge to edge perfect rare tenderloin with an incredibly flavorful crust. We usually do rib roast the same exact way and it’s fantastic. This is actually even better.

#BBQ #bbqporn #foodie #foodporn #instafoodie #grilling #portablekitchen #GloucesterMA #northeastbbq #rublife #barbeque

Christmas Eve Roast Recipe For The @PKGrills #PK360

It’s pretty straightforward.

Trim away any huge globs of visual fat.

Use some butchers twine to form up the roast so it is symmetrically circular by cinching up the twine.

Make slits every three inches or so on the roast and insert thinly sliced slivers of garlic.

Slather on some Worcestershire sauce, then a mix of coarse salt/restaurant grind black pepper/ garlic /sage/rosemary/thyme.

Let it sit on counter for an hour or so to get up close to room temp.

Put about a chimney full of unlit charcoal in the right hand side of the PK 360 liberally sprinkled with wood chips.  I used cherry.

Light about ten briquettes in the chimney and once glowing place them on one corner of the unlit charcoal.

Place some foil or foil trays under where your roast will sit.

Place remote thermometer probe and close the lid.

Once the temps climb to 200, close the top vent over the lit charcoal, leave the vent on the opposite side open.  Close the bottom vent under where the meat will be placed and leave the bottom vent under the coals about 2/3 open.

Place the meat opposite the coals, over the drip pan or foil, stick the meat thermometer probe in the thickest part of the roast.

You’re looking for 250 degree pit temp.  If it wants to run at 275- no problem, If it wants to run at 225, no problem.  Wherever it settles in that range, you’re good.

If you follow these directions you’ll have edge to edge pink meat with a nice crust.

When the internal temp gets to 117, pull it off and lightly wrap it in foil .

Open the lid so the remaining coals fire up and get a little orange glow going.

Place the roast back on the pit, but this time directly over the coals.

Pay close attention, you want a sear but not a burn.   About a minute and roll, then a minute and roll, til the roast is seared all around.

Once you get that sear all the way around place it on a tray and then loosely tent the foil around it.  You can keep it like that for a couple hours.  it will retain the meat.

Slice it and you’ll discover a perfectly cooked even pink edge to edge roast.

 

 

Avocado stuffed with crabmeat topped with panko on the @PKGrills #PK360

For more from my BBQ Blog visit http://www.northeastbbq.com

A9CCF62C-1540-4241-986A-7FCF49DB6F2B4357A0B2-4355-4751-A41D-0B338E7E8DBD92FC7329-B6A9-415F-84BC-46C4D7FE6564773A3BAE-2459-4135-AB6A-35C8586AFB28

First Low and Slow Session On The @PKGrills #PK360 Chuckie For Pulled Beef Sliders

Set up for my first low and slow session on the @pkgrills #pk360 A four lb #chuckroast for pulled beef sliders. Filled right side of the pit with unlit charcoal then added 12 ashed over lit coals in the top right corner of the pile. Cherry wood for smoke. Chuckie hit the cooking grate at 250 degrees. Foil pan underneath. Will wrap when internal temp hits 170. Will pull off when roast is fork tender to pull.

Here are the vent settings for the low and slow 250 degree grate temp-

Bottom left vent closed completely.  Bottom right vent open half way.  Top right vent closed completely. Top left vent (above the meat) closed half way.

wp-1503264278630.

20170820_165256-01